ASI 160 24 Inch Security Grab Bar Grab Bar

Home > Security Accessories >

ASI 160 24" L Security Grab Bar 1-1/2" (38mm) OD - Chase Mount

Alternative Views:

List Price: $215.70

Our Price: $118.60

Savings: $97.10

Manufacturer: ASI
Availability: Usually Ships in 2-3 Business Days

Product Code: 160

Wall Thickness*:

Less than 6"
6" to 8"
Over 8" - Specify in Order Notes

Qty:

Description

Technical Specs

ASI 160 24" L Security Grab Bar 1-1/2" (38mm) OD - Chase Mount

Construction

Security Grab Bar (Rear Mounted) shall be fabricated of alloy 18-8 stainless steel, type 304. All exposed surfaces shall have satin finish. Flanges shall be 1/8" thick and shall be completely welded to tube end. Tubing shall be 1-1/2" diameter with 18 gauge wall. Each flange shall have three (3) welded-on 1/4-20-UNC-2B internally threaded studs with threaded rod length specified at time of order to suit wall thickness and shall be provided with three (3) each washers and nuts for mounting. Closure plate welded on bottom shall be 12 gauge stainless steel type 304 alloy 18-8 and shall fit closely to flanges and a straight line between rear face mounting surface of flanges.

Installation
Surface mount unit to finished wall through six (6) pre-drilled openings (by others) and secure unit to wall with washers and nuts (supplied) or other continuous anchor/backer material (by others) to suit local codes and wall conditions. The length of the threaded rods is determined by the thickness of the wall on which the unit is mounted. Specify the thickness of the wall.

For compliance with ADA Accessibility Guidelines install unit so that the top of the grab bar is 33" minimum above finished floor (AFF) to 36" maximum AFF.

ASI grab bars are designed to meet and exceed ADAAG requirements as published in ICC/ANSI A117.1-2003 and CFR 28 Part 36, revised as of 1 July 1994, that fabricated product shall be of adequate strength to support a load of 250 pounds (113.4 kg). Mounting to the wall is a critical part of the system to meet this requirement. To withstand the shear, tension or pullout and torsion loads generated by the maximum loading, the fastener system must be adequately sized. The product is capable of holding in excess of 1350 lbs (612.4 kg) when properly installed.

Warranty
One (1) Year Manufacturer's Warranty - Warranted to be free of defects in material or workmanship for one (1) year from date of sale.

Additional Options

Custom Grab Bar configurations and sizes are available.

Call us at 920-569-0895 ext. 2 or email [email protected] for pricing and lead times.