 |
Construction
Grab Bar with Snap On Flange covers for concealed mounting are type 304 stainless steel alloy 18-8. Tubing is 1-1/2"
diameter x 18 gauge. Snap on cover shall be 22 gauge. Flange is 1/8" thick and shall be Heliarc welded to
tubing with a continuous concealed bead. End flanges shall have two (2) 5/16" dia. mounting holes. If any center posts, they will have two (2) keyhole slots to ease installation access.
All exposed surfaces are Satin Finish Stainless Steel. Optional non-slip peened Surface denoted on part number with -P (peened).
ASI Grab Bars are designed to meet and exceed ADA requirements as published in CABO/ANSI A117.1 and
2010 ADA Accessibility Standards.
Mounting to the wall is a critical part of the system to meet this requirement. To withstand the shear, tension or
pullout, and torsion loads generated by the maximum loading, the fastener system must be adequately sized.
Installation
Use grab bar as template to mark mounting holes locations and pre-drill holes. Install bar using two (2) No. 10 self tapping
pan head screws and flat washers (by others - see item 3901 in Accessories listed below) or other fastener system (by others - see Accessories listed below for grab bar mounting kits) to suit conditions for
each flange. Appropriate anchoring and backing must be provided in accordance with local building codes or as
specified on Architects Plans prior to wall finishing.
For compliance with ADA Accessibility Guidelines install
unit so that the top of the grab bar is 33" minimum above finished floor (AFF) to 36" maximum
AFF.
Warranty
One (1) Year Manufacturer's Warranty - Warranted to be free of defects in material or workmanship for one (1) year from date of sale.
Additional Options
Custom Grab Bar configurations and sizes are available.
Call us at 920-569-0895 ext. 2 or email [email protected] for pricing and lead times.
|
|
|
Wall to Floor Concealed Mount Grab Bar 
